- Connection between two equipments or two networks
- Ready to use, nothing to configure
- 5 GHz IEEE 802.11a WiFi band (108 Mbps)
- Secured radio link with pre-configured WPA2
- 10/100 Base TX RJ45 auto-sensing network interface
- AC/DC block adapters supplied
Ethernet-Air-Pack is a ready-to-use solution designed to replace any Ethernet cable between equipments (PC, IP video, printers ...), replace the network cable between the RJ45-wall outlet and the computer or even to establish a wireless bridge between two independent Ethernet networks (between two buildings, two PLC's networks ...).
The kit is built around two pre-configured WiFi units already associated, installation doesn't require any configuration.
Ethernet-Air-Pack relies on the WiFi 5 GHz standard (IEEE 802.11a) which is not widely used by WiFi equipments. This offers a good level of protection against perturbations generated by existing WiFi networks; you can install as much Ethernet Air-Pack as cables to be replaced.
|Ethernet Air-PACK||Ready-to-use Point-to-Point wireless Ethernet bridge kit including two independent radio units with 2 dBi antennas, two +12VDC power supplies and two RJ45 cross Ethernet cables (1 meter)|
|Ethernet link||10/100 Base TX Ethernet interface, RJ45 connector|
|Radio link||Compliant with WiFi IEEE 802.11a, data rate up to 108 Mbps|
|Power, sensitivity||Transmitter +20 dBm, Receiver –92 dBm, one 5 GHz 2 dBi antenna|
|Signaling||LAN & WLAN activity on LEDs|
|Administration||SNMP and ACKSYS NDM|
|Power supply||+9VDC to +48VDC power source, PHOENIX connector, 3.5 Watts typical, 5 Watts maximum|
|Dimensions & weight||Small sized enclosure L: 103 x W: 67 x H: 23 mm, weight 225 g|
|Environment||Operating temperature: 0°C to +70°C, storage: -40°C to +80°C Humidity: 5% to 95% (non-condensing)|
|Ethernet Air-PACK||Ethernet Air-Pack Ready-to-use point-to-point wireless Ethernet bridge|